![Free new movie downloads](https://cdn1.cdnme.se/5447227/9-3/6_64e61dfae087c31b411cc5f3.png)
![dynamically allow the switch to learn mac addresses of pcs on vlan dynamically allow the switch to learn mac addresses of pcs on vlan](http://i2.wp.com/howdoesinternetwork.com/wp-content/uploads/2011/12/5-Switch-mac-address-table-full-of-bogus-mac-addresses-acts-like-a-hub.jpg)
This way, traffic between any two switches is not broadcast to the other switches. Other hosts using the forged MAC address of Host A cannot obtain the frames destined for Host A.įor example, in the following topology, switch A learns the MAC addresses of ports on switch B, C, and D. Then, the frames destined for Host A are always sent out of port A.
![dynamically allow the switch to learn mac addresses of pcs on vlan dynamically allow the switch to learn mac addresses of pcs on vlan](https://forum.huawei.com/enterprise/en/data/attachment/forum/202108/20/013523x0l0x7znow0y0wab.jpg)
To improve the security for Host A, manually configure a static entry to bind Host A to port A.
![dynamically allow the switch to learn mac addresses of pcs on vlan dynamically allow the switch to learn mac addresses of pcs on vlan](https://geek-university.com/wp-content/uploads/2015/10/show_interfaces_trunk_command.jpg)
When an illegal user sends frames with MAC A as the source MAC address to port B, the device performs the following operations: When Host A is connected to port A, a MAC address entry will be learned for the MAC address of Host A (for example, MAC A). Mac-address-table age-time), after which they are automatically deleted.ĭynamic MAC address learning does not distinguish between illegitimate and legitimate frames, which can invite security hazards. Dynamic entries remain in the table for a predetermined amount of time (defined with the command If the retrieved address does not exist in the table, it is added. Dynamic: Dynamic entries are automatically added to the table through a process called MAC learning, in which the switch retrieves the source MAC address (and VLAN ID, if present) of each Ethernet frame received on a port.Static entries remain active until they are removed by the switch administrator. Static entries have higher priority than dynamic entries. Static: Static entries are manually added to the table by a switch administrator.The MAC address table can contain two types of entries: The table enables the switch to send outgoing data (Ethernet frames) on the specific port required to reach its destination, instead of broadcasting the data on all ports (flooding). The MAC address table is where the switch stores information about the other Ethernet interfaces to which it is connected on a network.
![Free new movie downloads](https://cdn1.cdnme.se/5447227/9-3/6_64e61dfae087c31b411cc5f3.png)